CE5000-UM-251-9370 7-11
7 ELECTRICAL ADJUSTMENTS
7.9 Adjusting the Auto-Registration Mark Sensor Sensitivity
If the main board (PN5043-01) later than B version was installing to the CE5000, you need to adjust the
sensitivity when the CE5000 has the Auto-registration mark sensor option.
Do not perform this adjustment when the A version of main board (PN5043-01) was installing to the CE5000.
How to adjust the auto-registration mark sensor sensitivity
(1) Load an A4 (Letter) or larger size sheet of paper in the plotter. The paper color must be white, and it is
recommended that high-quality paper made for ink-jet printers be used.
(2) Position the white aria of paper under the Registration Mark Sensor.
(3) Turn on the power while pressing the TEST and ENTER keys.
(4) Select the media mode.
(5) Press the PAUSE key to display the menu shown below.
(This menu is not displayed when the main board is new type.)
MODEL SELECT
(6) Press the NEXT key until the following menu is displayed.
MARK SENSOR ADJ.
(7) Press the ENTER key to start registration mark sensor sensitivity adjustment.
(8) Keep pressing the ENTER key to display the menu shown below.
50
Confirm that the level is 55 from 50.
If the level was not 55 from 50, readjust again.
When making this adjustment, make sure that the media does not rise up from the cutting mat surface.
(9) Press the NEXT key to complete this adjustment.
