6
In-Roof System Installation
34
In-Roof System
Installation
Figure 71:
Fixing of the Top Brackets
Figure 69:
Installation of the Collectors on to Bracket
Figure 70:
Installation of the Top Brackets
2. Fit two anchor blocks (05) into the
profile at the bottom and top of
each collector. Lift first collector and
position on two mounting brackets.
See Figure 69. Adjust position of
anchor blocks to align with hole in
each mounting brackets. Repeat for
second collector, and so on for
further collectors.
3. Install the top mounting brackets
after collectors have been fitted
onto bottom mounting brackets.
Remove the protective film from the
underside of two mounting
brackets. Lift top end of one
collector and position the two
mounting brackets (with the holes
at the top) against the top edge of
the collector. Lower the collector
and press the bracket into place on
the base tray. Fix in place with the
self-drilling screws supplied in the
kit using a Torx 25 screwdriver.
Refer to Figure 71.
4. Adjust position of the two anchor
blocks in top collector profile to
align with the hole in the two
mounting brackets. Fit the two
cylinder bolts through the top
mounting brackets into the anchor
blocks and tighten. Repeat for
bottom mounting brackets.
5. Repeat procedure for second
collector, and so on, as required.
6.5 Fitting Top Cover Flashing
Note:
Flow and return system pipework,
and connections between collectors,
should be completed and tested
before fitting closure strip(s) and top
cover flashings to collectors.
1. First fit closure strip to cover the
gap between two collectors. Locate
one of the two long flanges on the
underside of the closure strip against
the side of one of the two adjacent
collectors. Push on the other flange
until the closure strip clips into
place between the collectors.
2. Ensure that the closure strip is
contact with the collector sides over
its entire length. Slide the closure
strip up or down, as necessary, to
align it with the top and bottom with
the ends of the collectors. Fold the
closure strip ends over the top and
bottom of the collectors to secure
the closure strip in place.
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [email protected] 0844 556 1818