3
Install Island Side Panel
Sets
Insert 2 Socket Head Cap Screws 1/4"x3/4" into the Bowl Frame Trim Panel/Left. Tighten and secure
using the Wrench/M3 as shown.
With your assistants, lift the Side Panel, Left/Island and slide it towards the Left Island Side Bracket
Assembly. Insert the 2 Electric Wires from the left side of the Control Panel into the holes on the Bowl
Frame Trim Panel/Left and the Side Panel, Left/Island as shown. Align them by making sure the 2 Socket
Head Caps in the Bowl Frame Panel go into the holes in the Island Side Panel Bracket Assembly.
Open the Left Island Door. Find the ends of the 2 Socket Head Cap Screws (they should be where the
Bowl Frame Trim Panel/Left and Side Panel, Left/Island meet). Install 1 Plain Washer 5/16" onto each
Socket Head Cap Screw. Secure by installing 1 Wing Nut 1/4" on top of each washer.
Repeat previous steps for the Side Panel Right/Island.
If the Island Side Panels and the Grill are not level with each other, use the wrench to adjust the level
adjusters on the bottom of the Bracket Assemblies.
Turn the adjusters clockwise to raise the height of the Grill.
Turn the adjusters counterclockwise to lower the height of the Grill.
FOR YOUR SAFETY DO NOT TILT your Grill at any time.
Wing Nut 1/4"
Qty. 4
Part # S355G04001
Socket Head Cap
Screw 1/4"x3/4"
Qty. 4
Part # S164G04121
Wrench/M3
Qty. 1
Part # P05515006B
9
W rench
Qty. 1
Part # P05515129C
Plain Washer 5/16"
Qty. 4
Part # S411G05101
•
•
•