USE AND CARE INSTRUCTIONS
Grill Lighting Instructions
19
Before each use, check all hoses for cracks, nicks, cuts,
burns, or abrasions. If a hose is damaged in any way,
do not use your grill before replacing the hose with an
authorized part from the Parts List. Also make sure all
gas supply connections are securely tightened.
Familiarize yourself with the safety and Use and Care
instructions in this Guide. Do not smoke while lighting
grill or checking gas supply connections.
Be sure the LP Gas tank is filled, and lock Casters to
prevent movement during grill operation.
Open the Grill Lid.
1.
8.
7.
4.
3.
2.
If ignition does not occur in 5 seconds, turn gas off at
source and turn Control Knobs OFF. Wait at least 5
minutes for gas to clear, then retry. If your grill still fails
to light turn the burner Control Knob(s) and gas source
OFF and conduct a leak test of ALL gas connections
and gas sources as explained in the Use and Care
section of this guide. If no leaks are detected, wait 5
minutes for any gas to clear and repeat the lighting
procedure.
If the burner indicator light does not work, check the
LCD Battery Pack.
After one Burner is lit, turn the tank valve SLOWLY one
more 1/4 of a turn. If other burners need to be lit, turn
each other burner knob to to light, then back to
.
9.
Failure to replace a faulty hose, secure gas supply
connections or to open the Lid before proceeding to
the Lighting Procedures could result in a fire or
explosion that could cause serious bodily injury, death,
or property damage.
WARNING
!
!
Note: Place the Lighting Stick inside the basket on
the Right Cart when it is not in use.
Infrared Burners
•
OFF
Left Front
Burner
Right Front
Burner
Right Rear
Burner
Left Rear
Burner
Manually Lighting Your Grill By Paper Match
To light your gas grill by match, insert a match into the
Lighting Stick and follow steps 1 through 5 of the Grill
Lighting Instructions. Then, light the match and place
Lighting Stick through the Cooking Grid on the grill as
shown below. Turn the nearest Control Knob to the setting
to release gas. The Burner should light immediately.
Set Control Knobs to OFF and open the LP Gas tank
valve
SLOWLY 1/4 of a full turn
. For Natural Gas, open
the Shut Off Valve at the source.
Push and turn the control knob to and hold it in 3-5
seconds to ignite the Burner. Once the burner is ig-
nited, continue to depress the knob and rotate to .
Turn on the LCD panel, hold the knob until burner indi-
cator light turns on then release it.
5.
6.
Open LP Gas tank
OFF
•