Grady-White Boats EXPRESS 265, Owner'S Manual

Page: 36 / 74

M
AINTENANCE AND
S
ERVICE
6–4
M
AINTENANCE
To maintain your boat's top and other canvas follow these guidelines:
Fabric should be cleaned regularly to prevent the buildup of soil and soil penetratation of the
fabric. Simply brush off any loose dirt, hose down canvas and clean with a mild solution and
warm water. Do not use petroleum-based or ammonia cleaners on canvas or clear vinyl as they
will yellow. For heavily soiled fabric, remove top from frame. Soak the fabric in a solution of
1/2 cup of Clorox™ and 1/4 cup of Ivory or Lux soap per gallon of warm water. Let soak until
mildew and stains can be brushed out with a common kitchen brush. Rinse thoroughly with
cold water until all soap is removed. Allow fabric to air dry completely.
DO NOT STEAM
PRESS OR DRY IN AN ELECTRIC OR GAS DRYER . This will damage the canvas fab-
ric. Water repellent was applied to your canvas during manufacturing. After extended cleaning
some of the repellent may have diminished and re-treatment of the fabric is recommended. Do
not use wax-based products. Use a water based repellent like *Apseal® or Uniseal™. Scotch-
guard® is effective for short-term use only.
S
NAPS
A
ND
Z
IPPERS
To protect the snaps and zippers on your boat’s canvas and cushions from corrosion and bind-
ing, Grady White includes a snap/zipper assist tool and a tube of lubricant (E-Z Snap™) in
your owner’s packet. The lubricant, manufactured by IOSSO (part number 10909), should be
applied per the manufacturer’s directions during the initial use of your canvas and cushions.
The lubricant should be reapplied every 3 months or sooner depending on your boating envi-
ronment and usage. The snap/zipper assist tool included in your owner’s packet should be
used whenever you remove the canvas,cushions, or operate the zippers to prevent damaging or
tearing the material. In the event you need to replace your assist tool or reorder the lubricant,
contact your dealer.
V
INYL
•Clean clear vinyl thoroughly with denatured alcohol, and then apply a protective layer of
clear wax. Do not use paste wax, as it will turn the vinyl yellow. This process should be
repeated as necessary to maintain the protective wax coating.
•Store and secure canvas before trailering.
•Dry all canvas before storing to prevent mildew.
•Remove the top, front and side panels; roll them for storage. This procedure is necessary to
prevent the front and side vinyl pieces from cracking. NEVER FOLD THESE PIECES!
S
TORAGE
Consider the following steps when putting your folding top canvas option in the stored posi-
tion:
•Fold the top and zip it into the canvas cover provided.
•Pivot the covered top into the stowed position on the foredeck. The canvas cover is
equipped with a strap on each side and an eyelet in each strap. Place the eyelets over the
male fasteners located on the port and starboard foredeck.
•Twist the male fastener 90 degrees to engage.
C A U T I O N
Secure the folded top when in the stowed position,
this will prevent damage or the loss of your canvas.
!