Graco Therm-O-Flow 200, Instructions-Parts List Manual, Page: 17 / 109

Setup
Install Install Install Heated Heated Heated Hose Hose Hose
To connect a hose to a fluid control device or heated
manifold.
1. Install fitting and heated hose onto pump outlet
with the large electrical connector side toward
the system. Use 2 wrenches to tighten hose.
Torque to 45 ft-lbs (61 N•m).
Note
See Accessories and Kits, page 88 for
available fittings and heated hoses.
Figure 9
2. Wrap exposed fittings on the pump outlet with
Nomex insulation and secure insulation using
fiberglass tape.
3. Connect large heated hose connector to MZLP.
4. Repeat for any remaining channels.
5. For proper operation, cables must be plugged
into zones 1–2 and 3–4 at all times.
6. Install cap on any unused MZLP electrical
connectors.
7. Connect the small 8 pin connector from the
heated hose to the fluid control device or heated
manifold.
Figure 10 Heated Manifold 243697
Note
The heated manifold (part
no. 243697) shown. See
Accessories and Kits, page 88 , for
available manifolds and fluid control
devices.
8. Use 2 wrenches to tighten hose. Torque to 45
ft-lbs (61 N•m).
9. To connect multiple devices, see
Connect Multiple Devices, page 18 .
334130D 17