![background image](http://html1.mh-extra.com/html/graco/sd-composite-hr/sd-composite-hr_instructions-manual_2253101016.webp)
Installation
16
313431H
Hose Installation
Installing a Hose on a Bare Reel
1.
Locate length of your hose in table below. Note how
many times you must turn the spring to properly pre-
set spring tension.
2.
Before you install hose, attach a C-Clamp (D) to reel
flange to help prevent the reel from unintentionally
becoming unlatched and spinning freely. (F
IG
. 11).
3.
Place a piece of tape on the side of the reel flange
to use as a visual reference to help you count the
number of reel turns.
4.
Wearing heavy gloves, firmly grab the outside edge
of the reel flange with both hands. Wind the reel the
proper number of turns (See reference table follow-
ing Step 1), rotating it in the direction shown in F
IG
.
11.
•
Stop only at latching locations.
•
Stop reel where there is access to hose swivel
(A) (F
IG
. 12) and where reel is securely latched.
5.
Uncoil and extend hose.
6.
Install hose stop (C) to end of hose. If hose has a
warning tag (F), hose stop should be installed on
the same end of the hose as the warning tag.
7.
Run the end of hose (B), through the hose guide (G)
and then the hole (E) in reel (F
IG
. 12).
8.
Attach hose end (B) to hose reel swivel (A). Then
carefully remove C-Clamp (D) (F
IG
. 11).
9.
Pull hose hard enough to release the latch, and
slowly allow the hose to retract.
Hose Length
No. of Reel Turns
35 ft (10.7 m)
17
50 ft. (15.2 m)
21
65 ft. (19.8 m)
23
Never allow the reel to spin freely. Doing so causes the
hose reel to spin out of control, which could cause serious
injury if you are hit by the hose or other moving parts
Always wear heavy gloves when you adjust spring tension
to protect your hands from being cut on hose reel.
F
IG
. 11
F
IG
. 12
D
B
ti13191
A
B
C
E
ti13190
F
G
Summary of Contents for SD Composite HR
Page 41: ...NOTES 313431H 41 NOTES...