Maintenance
313431H
25
Replacing the Service Hose
1.
Relieve the pressure
.
2.
If the hose reel is enclosed, remove enclosures as
necessary to access hose reel (F
3.
Fully extend the hose (B) and latch the reel.
4.
Attach a C-Clamp (A) to the reel flange to help pre-
vent the reel from unintentionally becoming
unlatched and spinning freely (F
5.
Remove hose stop from hose end and put all the
parts in a safe place to reinstall on the new hose
later (F
IG
. 23).
a.
Loosen and remove screws (aa) and nuts (bb).
b.
Separate two hose stop components (cc) to
remove from end of hose.
6.
Disconnect hose (B) from swivel (C) (F
completely remove the hose from reel.
7.
Install hose stop (D) to end of hose. If hose has a
warning tag, hose stop should be installed on the
same end as the warning tag (F).
8.
Insert screws (aa) through hose stop (cc) and hand
tighten nuts (bb) to hold hose stop in place.
9.
Run the end of hose (B), through the hose guide (G)
and then the hole (E) in reel (F
Never allow the reel to spin freely. Doing so causes the
hose reel to spin out of control, which could cause serious
injury if you are hit by the hose or other moving parts.
F
IG
. 22
ti13184
A
B
F
IG
. 23
F
IG
. 24
cc
aa
bb
C
B
D
E
ti13190
G
F
Summary of Contents for SD Composite HR
Page 41: ...NOTES 313431H 41 NOTES...