![background image](http://html1.mh-extra.com/html/graco/sd-composite-hr/sd-composite-hr_instructions-manual_2253101024.webp)
Maintenance
24
313431H
8.
Lay hose reel on its side so you can easily access
the guide arm and pedestal (24 / 30). Remove long
bolt (18) and washers (15 / 17) (F
9.
Remove snap ring (5e) (F
. 20).
10. Remove guide arm and pedestal base (24 / 30) as
one piece. These parts do not have to be disass-
sembled.
NOTE:
Inspect inside of guide arm to make sure
washer (5j) is not adhering to the inside of the guide
arm. Washer (5j) should be discarded with the old
spool. A new washer (5j) is part of the new swivel
assembly.
11. Remove and discard old spool.
To Reassemble Spool:
12. Place new spool (5) on its side on a work bench.
Make sure the flat side of the spool faces down on
the table and the ratchet side is facing up, as shown
in F
13. Position guide arm and pedestal base (24 / 30)
assembly over spool. Adjust as needed to correctly
align parts.
NOTE:
It is easier to reattached the guide arm and
pedestal assembly to the spool if the spool is sup-
ported and somewhat level. Placing a couple blocks
of 1” thick scrap wood under the spool as shown in
F
. 20 (page 23) will help support the spool during
the arm installation.
14. Replace snap ring (5e).
15. Install new swivel assembly in spool (see parts page
16. Install washers (15 / 17) and long bolt (18), but do
NOT tighten bolt.
17. Turn the spool over.
18. Install guide arm and pedestal assembly (26 / 29)
over swivel assembly and spool.
Note shape (a) of swivel assembly end shown in
F
. 21 and the correct alignment of swivel to the
key hole in the pedestal. For the hose reel to oper-
ate correctly, these parts must be aligned correctly.
NOTE: HN models do not have a guide arm.
Guide Arm and related parts are not included.
19. Install large nut (11) (F
. 19, page 23). Tighten and
torque nut to 85-105 ft. lbs (378 - 467 N.m).
20. Tighten bolt (18).
21. Align guide arm (29) and guide arm (30). Install
screws (27). Tighten and torque screws to 20-30 ft.
lbs (89 - 133 N.m).
22. Align pedestal assembly (26) to base (24). Install 2
screws (27). Tighten and torque screws to 20-30 ft.
lbs (89 - 133 N.m).
23. Re-install reel to ceiling or wall.
24. Install hose on spool following the Hose Installation
instructions, page 16.
25. Flush hose following flushing instructions starting
26. Set spring tension following Increasing and
Decreasing Spring Tension instructions on page 18.
F
IG
. 21
a
Summary of Contents for SD Composite HR
Page 41: ...NOTES 313431H 41 NOTES...