INSTALLATION
Models 225–006 and 225–026
1.
For Model 225–026: Assemble the truck (3) as
shown in the parts drawing on page 11.
For Model 225–006: Assemble the base (3) as
shown in the parts drawing on page 12.
2.
Screw the holster (6) into the pump outlet.
3.
Place an opened 120 lb drum of grease on the
mounting base or truck, and secure it with the hold
down clamps. Use the blunt end clamps (3e) only
with fibre drums
(supplied with Model 225–006 only).
Use the pointed end clamps (3d) only with steel
drums. Position the clamps above the drum bead.
Tighten the thumbscrews (3c).
4.
Press the follow plate (5) down firmly onto the grease
and rotate it to eliminate air pockets and reduce
channeling. Insert the pump through the cover (4)
and slide the cover up far enough to let the pump
pass easily through the follow plate grommet.
5.
Secure the cover on the drum with the thumbscrews.
It is not necessary to bolt the pump to the cover.
6.
Assemble the gun (2b) and hose (2a), and then con-
nect the hose to the pump fluid outlet.
7.
Connect the nipple (2d) to the pump air inlet. Connect
the quick disconnect coupler (2c) to the air supply
hose.
2a
2c, 2d
4
5
6
2b
3c
3e
3d
2c, 2d
Model 222–069
1.
Remove the cover from the pail and scoop the
lubricant from the center to the sides of the pail
to make its surface concave.
2.
Center the follow plate (5) in the pail opening.
Press the plate firmly downward and rotate it
over the lubricant surface to eliminate air
pockets and prevent channeling.
3.
Place the cover (3a) on the pail, and tighten
the thumbscrews (3f).
4.
Assemble the gun (2b) and hose (2a), and
then connect the hose to the pump fluid outlet.
5.
Connect the nipple (2d) to the pump air inlet.
Connect the quick disconnect coupler (2c) to
the air supply hose.
2a
2b
3a
5
3
3f
Summary of Contents for Ratio Fire-Ball 225-003
Page 2: ......
