![background image](http://html.mh-extra.com/html/graco/linelazer-iv-250sps/linelazer-iv-250sps_repair-manual_2250943040.webp)
Rear Wheel and Wheel Motors
40
3A2593C Repair
Rear Wheel and Wheel Motors
Rear Wheel Removal
1. Set LineStriper on blocks so wheels are off ground.
2. Remove four lug nuts (22) and wheel (16).
Rear Wheel Installation
1. Replace wheel and install lug nuts. Alternately
tighten lug nuts opposite of each other.
2. Tilt LineStriper on side and remove blocks.
3. Inflate rear tires to 55 +/- 5 psi (380 +/- 34 kPa).
Wheel Motor Removal
1. Place jack under frame near wheel and raise jack.
2. Remove four lug nuts (22) and wheel (16).
3. Remove pin (56), castle nut (21b) and wheel hub
(22b). Wheel hub may require a wheel puller; not
supplied by Graco.
4. Remove screw (6) and distance sensor (4) with
clamp (5).
5. Remove four bolts (78), lock nuts (79) and fender
(19).
6. Disconnect two hydraulic hoses (112) from wheel
motor (21a) and remove wheel motor.
ti18587a
ti18589a
22
16
ti18588a
ti18589a
22
16
ti23945a
4
78
79
22b
21b
56
19
6
5
21
a
112
Summary of Contents for LineLazer IV 250SPS
Page 53: ...Notes 3A2593C Repair 53 Notes ...