Warnings
3A2593C Repair
5
PRESSURIZED ALUMINUM PARTS HAZARD
Use of fluids that are incompatible with aluminum in pressurized equipment can cause serious chemical
reaction and equipment rupture. Failure to follow this warning can result in death, serious injury, or prop-
erty damage.
•
Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or flu-
ids containing such solvents.
•
Do not use chlorine bleach.
•
Many other fluids may contain chemicals that can react with aluminum. Contact your material supplier
for compatibility.
ENTANGLEMENT HAZARD
Rotating parts can cause serious injury.
•
Keep clear of moving parts.
•
Do not operate equipment with protective guards or covers removed.
•
Do not wear loose clothing, jewelry or long hair while operating equipment.
•
Equipment can start without warning. Before checking, moving, or servicing equipment, follow the
Pres-
sure Relief Procedure
and disconnect all power sources.
MOVING PARTS HAZARD
Moving parts can pinch, cut or amputate fingers and other body parts.
•
Keep clear of moving parts.
•
Do not operate equipment with protective guards or covers removed.
•
Pressurized equipment can start without warning. Before checking, moving, or servicing equipment, follow
the
Pressure Relief Procedure
and disconnect all power sources.
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
•
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
•
Do not exceed the maximum working pressure or temperature rating of the lowest rated system compo-
nent. See
Technical Data
in all equipment manuals.
•
Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equip-
ment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your
material, request MSDS from distributor or retailer.
•
Do not leave the work area while equipment is energized or under pressure.
•
Turn off all equipment and follow the
Pressure Relief Procedure
when equipment is not in use.
•
Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manufac-
turer’s replacement parts only.
•
Do not alter or modify equipment. Alterations or modifications may void agency approvals and create
safety hazards.
•
Make sure all equipment is rated and approved for the environment in which you are using it.
•
Use equipment only for its intended purpose. Call your distributor for information.
•
Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
•
Do not kink or over bend hoses or use hoses to pull equipment.
•
Keep children and animals away from work area.
•
Comply with all applicable safety regulations.
•
Do not carry passengers.
•
Check work area for reduced overhead clearance (e.g. doorways, tree branches, parking ramp ceilings)
and avoid contacting them.
WARNING
Summary of Contents for LineLazer IV 250SPS
Page 53: ...Notes 3A2593C Repair 53 Notes ...
