Installation
3A5056B
9
Mounting and Dismounting to
DIN Rail
This device is intended to be mounted on a 35 mm stan-
dard DIN rail.
The DIN rail mounting clip on the device is
spring-loaded. No tool is needed to install or remove the
device.
A force of approximately 40 lbs (18 Kg-force, 180 N) is
necessary to compress the spring enough to allow the
DIN rail clip to be latched onto the rail.
The spring must be latched behind the edge of the DIN
rail to connect properly. See F
To remove the device from the DIN rail, pull down to
compress the spring, pull the bottom out to release it
from the rail, and lift it up off the top of the DIN rail.
F
IG
. 3: DIN Rail Mounting
Rail mounting
clip
