Graco E-flo iQ 26B543, Installation-Parts

Page: 28 / 80

Setup
28 3A8217A
Dispense Valve Solenoid
3. If using a Single iQ Ram Supply System:
a. Connect the solenoid valve cable (VC) to the
M8 4 pin end of the splitter cable attached to
Port 4 on the Electric Driver (AB). See
Electric
Driver Communication Connections for
Single Rams on page 16. See F
IG
. 24.
b. Connect the 90 degree end of the included M8 4
pin cable (VD) to the dispense valve, and the
straight end of the solenoid valve cable to (VC).
See F
IG
. 24.
4. If using an iQ Tandem Ram Supply System:
a. Connect the dispense valve solenoid cable to
the tandem dispense valve solenoid connector
(YY) on tandem block (R).
b. Connect the 90 degree end of the included M8 4
pin cable (15N040) to the dispense valve, and
the straight end of the solenoid valve cable to
(VC). See F
IG
. 24.
c. Connect one male end of the M8 4 pin splitter
(TT) on the tandem block (R) to the M8 4 pin
end of the splitter cable attached to Port 4 on
the Electric Driver (AB) for ram 1 and ram 2.
See
Electric Driver Communication
Connections for Tandem Ram s on page 17.
NOTE: Make sure the pins on the solenoid valve cable
are oriented as shown in F
IG
. 23 before the cable is
plugged into the solenoid valve.
Robot Connection (if used)
5. If using a Single iQ Ram Supply System:
a. Connect the included M12 8 pin cable with
flying leads (128441) to Port C4 of the power
junction box (AJ)
b. Flying leads of (128441) connect to robot
controller (not included).
6. If using a Tandem iQ Ram Supply System:
a. Connect the included M12 8 pin cable with
flying leads (128441) to discrete robot cable
connector (SS) on tandem block (R).
b. Connect M12 8 pin discrete robot splitter (RR)
to Port C4 of the power junction box (AJ) on ram
1 and ram 2.
c. Flying leads from (128441) connect to robot
controller (not included).
F
IG
. 23
Solenoid Valve
Solenoid Valve
Cable
F
IG
. 24
B
PA
PC
FT
VD
NN