Maintenance
10
3A8564C
Maintenance
Pump Lubrication
Frequency of greasing intervals is dependent on
material being pumped. As a basic schedule lubricate
pump with grease after 250 gallons of product (five
drums or fifty, five gallon pails) has been passed
through pump.
If the grease has become hardened, remove the seal
retainer (B) and remove the hardened materials or
grease. Shorten the intervals between greasing the
pump.
If the grease remains a clear and clean liquid the
intervals between greasing the pump can be extended.
Use Graco 0553-6 grease (138) or equivalent to
lubricate pump.
To grease the pump
1. Loosen M5 SHS EXT screw (102) two turns to
permit grease to circulate through pump correctly.
2. Attach grease gun to grease fitting (101) until fresh
grease is observed to come out grease relief hole
below the M5 SHS EXT screw (102). See F
. 6.
Recycling and Disposal
End of Product Life
At the end of the product’s useful life, dismantle and
recycle it in a responsible manner.
• Perform the
page 9.
• Drain and dispose of fluids according to applicable
regulations. Refer to the material manufacturer’s
Safety Data Sheet.
• Deliver remaining product to a recycling facility.
F
IG
. 6
B
101
102
