Graco Angelcare, Owner'S Manual

Page: 8 / 40

8
IMPORTANT: Only use the AC adapters included with your monitor. Do not use these adapters with any
other equipment. Movement Sensitivity Control. The movement sensitivity control is on the back of the
Nursery Unit. The level has been preset to 2.5 (see fig. 3). Do not adjust this unless you receive false
alarms. Refer to the Movement Sensitivity Adjustment section on Pg. 11 for more information. It is extremely
important to follow our instructions for setting the sensitivity level.
Now plug the Sensor Pad cord into the jack on the back of the Nursery Unit marked “Sensor Pad.”
Turn the Nursery Unit on using the switch on the left. The green Power Indicator will light up.
CORRECT
Sensor Pad Centered Turquoise Side Up
INCORRECT
Sensor Pad Off Center
INCORRECT
Sensor Pad Turquoise Side Down
POSITION OF SENSOR PAD UNDER MATTRESS
(Top Down View of Crib)
Sensor Pad Sensor Pad
CORRECT
INCORRECT
PLACEMENT OF SENSOR PAD CORD
Figure 1
fig. 2
SENSOR PAD
(See figs. 1 and 2)
Place the Sensor Pad under the center of the crib mattress with the blue side facing up. Do not place any loose bedding
or linen between the crib mattress and the Sensor Pad. The Sensor Pad must rest on a flat, firm surface. If your crib has
a spring or slat base, place a piece of Masonite board under the Sensor Pad. This support must measure at least 13
inches long on all four sides and 1/4 inch thick. (You may order a Masonite board directly from us.
Call Graco at 1-800-345-4109). If your crib has a plywood base, your mattress support is firm enough to use the monitor
properly. Only use your Angelcare® monitor in a stationary sleeping environment such as a crib where the Sensor Pad
can rest on a flat, firm surface. Be sure to place the turquoise side of the Sensor Pad facing up.
CAUTION: To avoid potential strangulation accidents resulting from loose cords or wires in the crib, make sure the
Sensor Pad cord passes underneath the mattress entirely. After positioning the Sensor Pad under the mattress, bring the
cord to the corner of the crib and secure it to the top and bottom of the leg of the crib, or wind it around the leg
(see fig. 1).
Setting Up Your Monitor
fig. 3
fig. 1
Movement Sensitivity Control.