Operation
18
3A8600B
Operation
Pressure Relief Procedure
Follow the Pressure Relief Procedure whenever
you see this symbol.
1. Turn the fluid air switch (BA) on the controller to the
OFF position. This will relieve air pressure to the
receiver head (J) (not included).
2. OPEN the Jet by pressing the Jet OPEN/CLOSE
button (BE) and using the key pad arrows (BF) to
toggle the setting to OPEN. This will open the Jet
and relieve any fluid pressure between the fluid
cartridge and nozzle (AE).
Prime the Jet
HV-2000b and HV-9500b
NOTE:
The nozzle plate (AA) and diaphragm (AH) must
be installed prior to priming the Jet.
1. Ensure the fluid pressure is OFF.
2. Set the fluid pressure to 0 psi.
3. Install the fluid syringe to the syringe bracket.
4. Install the receiver head (J) (not included) onto the
fluid syringe, and connect to the fluid air supply.
5. OPEN the Jet.
6. Turn the fluid air pressure ON.
7. Slowly increase the fluid pressure until a steady
stream of material is flowing from the nozzle (AE).
8. CLOSE the Jet.
HM-2600b
NOTE:
Material must be up to working temperature and
completely melted prior to priming the Jet. The nozzle
plate (AA), diaphragm (AH), and feed tube must be
installed and at temperature prior to priming the Jet.
1. Melt material in the syringe heater to the material
manufacturers recommendation.
2. Ensure the nozzle heat is up to temperature
according to the material manufacturers
recommendation.
3. Ensure the fluid pressure is OFF.
4. Set the fluid pressure to 0 psi.
5. Install the fluid syringe to the syringe bracket.
6. Install the receiver head (J) (not included) onto the
fluid syringe, and connect to the fluid air supply.
7. OPEN the Jet.
8. Turn the fluid air pressure ON.
9. Slowly increase the fluid pressure until a steady
stream of material is flowing from the nozzle (AE).
10. CLOSE the Jet.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury from
pressurized fluid, such as splashing fluid, follow the
Pressure Relief Procedure when you stop dispensing
and before cleaning, checking, or servicing the
equipment.
Summary of Contents for Advanjet 26B951
Page 21: ...Parts 3A8600B 21 Parts HV 2000b WL D...
Page 23: ...Parts 3A8600B 23 HV 9500b WL D...
Page 25: ...Parts 3A8600B 25 HM 2600b WL D...