![background image](http://html.mh-extra.com/html/graco/advanjet-26b951/advanjet-26b951_setup-and-operation_2251086017.webp)
Installation
3A8600B
17
Install a PUR Syringe, HM-2600b
1. Turn ON the heaters:
- Press
(INDEX) until Run-Stop (r-S) is
displayed on the Present Value (PV) line.
- Use the
arrows to select the
rUn
setting
on the Set Value (SV) line.
- Press
(
ENTER) to save the change. Heater
is ON.
- Press
again to return to the main screen.
2. To preheat the PUR, enter the Jet Set Value and
Fluid Set Value by pressing
on the
corresponding Temp Control panel. For most
materials, the following values can be used:
- Jet (nozzle): 130 °C (266 °F)
- Fluid (melter): 110 °C (230 °F)
3. Keep the top cap and tip cover ON a fresh syringe
of PUR, and insert it into the melter. Wait
approximately 10 minutes to allow the PUR material
to liquefy.
4. Remove the syringe top cap (save it to seal the
used syringe for disposal).
5. Use a clean probe tool to remove the layer of cured
material from the top of the melted PUR.
6. Have a waste container handy. Use a probe to lift
the syringe and remove it from the melter.
NOTE:
Hold the syringe as upright as possible to
prevent hot melted PUR from spilling out.
7. Reinstall the top cap. Hold the syringe over the
purge container and remove the tip cap, allowing
the liquefied material to drip out. If the material
does not flow freely, gently squeeze the syringe
until material extrudes from the nozzle tip, allowing
the liquefied material to flow freely. If the material
still does not flow, poke a probe into the tip and
clear it out.
8. Put the warmed syringe back in the melter. Push it
down firmly to position the syringe tip in the feed
tube, and turn it clockwise to engage the luer lock.
Do not over-tighten.
9. Attach the receiver head (J) and tighten the
thumbscrews.
Material inside the applicator can be very hot. To
avoid severe burns, wear protective gloves.
F
IG
. 22
Hold the syringe as upright as possible to prevent hot
melted PUR from spilling out and causing severe
burns.
Summary of Contents for Advanjet 26B951
Page 21: ...Parts 3A8600B 21 Parts HV 2000b WL D...
Page 23: ...Parts 3A8600B 23 HV 9500b WL D...
Page 25: ...Parts 3A8600B 25 HM 2600b WL D...