![background image](http://html.mh-extra.com/html/graco/advanjet-26b951/advanjet-26b951_setup-and-operation_2251086020.webp)
Troubleshooting
20
3A8600B
Troubleshooting
on page 18
before checking or repairing the Jet.
2. Check all possible problems and causes before
disassembling the Jet.
Problem
Cause
Solution
No material coming out of Jet
nozzle (AE).
Clogged nozzle (AE)
Clean nozzle (AE).
Inadequate fluid pressure
Verify fluid pressure is ON.
Verify the fluid pressure is high
enough.
Inadequate Jet pressure
Verify Jet pressure is ON.
Verify the Jet pressure is high
enough.
Faulty solenoid
Replace the solenoid.
Fluid nozzle heat is not ON
Turn the nozzle heat ON and verify
the heater timer settings.
Fluid nozzle heat is not high enough Verify the correct heat temperature
is set.
Material leaking from weep hole
No diaphragm (AH) installed
Verify the diaphragm (AH) is
installed.
Damaged diaphragm (AH)
Replace the diaphragm (AH).
Material leaking from the nozzle tip
Jet is OPEN
Verify the Jet is CLOSED.
Jet pressure is too low
Verify the Jet pressure is above 40
psi (0.28 MPa).
Fluid pressure is too high
Decrease the fluid pressure.
Summary of Contents for Advanjet 26B951
Page 21: ...Parts 3A8600B 21 Parts HV 2000b WL D...
Page 23: ...Parts 3A8600B 23 HV 9500b WL D...
Page 25: ...Parts 3A8600B 25 HM 2600b WL D...