2
309454C
Table of Contents
............................................................ 2
Common Terms
................................................. 2
Overview
............................................................. 3
Installation
......................................................... 4
Typical Installation........................................ 4
Pressure Relief Procedure........................... 4
Installation Procedure .................................. 5
Grounding .................................................... 6
Grease Dispenser Components .................. 6
............................................................ 7
Troubleshooting Chart
...................................... 8
................................................................ 8
Parts
.................................................................... 12
Technical Specifications
................................... 14
........................................................ 14
Graco Warranty
.................................................. 16
Graco Phone Numbers
...................................... 16
Common Terms
The following terms are shown on the Accu-Shot LCD
display and used in this instruction manual.
RESET BUTTON: when pressed, resets the Partial
Delivery total to zero.
CUMULATIVE TOTAL: non-resettable total. Displayed to
show the cumulative amount of grease dispensed. It
cannot be reset.
PARTIAL DELIVERY TOTAL: resettable total. Displayed
to show the cumulative amount of grease that has been
dispensed. It can be reset to zero.
WARNING
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result in
a serious injury.
•
This equipment is for professional use only.
•
Read all manuals, tags, and labels before operating the equipment.
•
Use the equipment only for its intended purpose. If you are uncertain, call your Graco distributor.
•
Do not alter or modify equipment. Use only genuine Graco parts and accessories.
•
Check the equipment daily. Repair or replace worn or damaged parts immediately.
•
Do not exceed the maximum working pressure of the lowest rated system component. Maximum
working air and fluid pressure of this equipment is 5000 psi (34.5 MPa, 345 bar).
•
Use fluids and solvents that are compatible with the equipment wetted parts. See the
Technical
Data
section of all equipment manuals. Read the fluid and solvent manufacturer’s warnings.
•
Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180
°
F (82
°
C) or below -40
°
F (-40
°
C).
•
Wear hearing protection when operating this equipment.
•
Comply with all applicable local, state, and national fire, electrical, and other safety regulations.
Summary of Contents for Accu-Shot 233807
Page 15: ...Notes 309454C 15 Notes ...