![background image](http://html1.mh-extra.com/html/graco/24w482/24w482_instructions-manual_2251211005.webp)
Installation
334662B
5
System Wiring
Timer Installation
1.
Connect timer leads to solenoid. A wiring harness
kit with a mating connector is available from your
Graco distributor.
Mating Harnesses
127899 - 8 inch harness with DELPHI 56 connector
127900 - 8 inch harness with DELPHI 280 connector
24P314 - 5 foot harness with flying leads
NOTE:
All connections between timer and solenoid
must be moisture-proof and safe from grounding.
2.
Connect the red lead wire to the positive side of the
vehicle ignition switch. Install a 5 amp fuse at this
connection.
3.
Connect the black lead wire to the chassis ground.
Installing the Lubrication
Controller
1.
Select a flat surface to install the Lubrication Con-
troller. Drill mounting holes. Refer to Mounting Hole
Layout Provided in the Technical Data section of this
manual, page 13.
2.
Align junction box with predrilled holes (F
IG
. 4, (a).
Use two screws (not provided) to secure junction
box to mounting surface.
AUTOMATIC SYSTEM ACTIVATION HAZARD
Unexpected activation of the system could result in seri-
ous injury, including skin injection and amputation.
This device has an automatic timer that activates the
pump lubrication system when power is connected or
when exiting the programming function. Before you
install or remove the Lubrication Controller from the
system, disconnect and isolate all power supplies and
relieve all pressure.
NOTICE
Do not ground the yellow wires to the solenoid. This
could cause damage to the timer.
F
IG
. 3
F
IG
. 4
a
a