Installation
307883L
9
Open Drum, Cover-Mounted Pumps
1. Remove the original drum cover.
2. Mount the new drum cover and fasten.
3. Install shim (4) (if applicable for your model) on
drum cover.
4. Guide the pump riser tube through the mounting
hole.
5. Align the drum cover eyelets (Q) with the hold down
rods (T), install the cover brackets (S) and wing nuts
(R) and tighten securely (see F
. 6).
M
Hold Down Rods
Q
Drum Cover Eyelets
R
Wing Nuts
S
Hold Down Brackets
T
Drum Locators
U
Hold Down Rod Lugs
Closed Bung-Type-Drum, Cover-Mounted
Pumps (F
IG
. 7)
1. Insert the pump riser tube through the gasket (W)
and drum cover (X). Fasten the Fire-Ball pump from
the top side and the Fire-Ball pump from the bottom
side.
2. Slide the rubber grommet (Y) tapered end down,
onto the riser tube and push it up against the pump
base.
3. Guide the pump riser tube through the drum bung
hole (Z) and place the cover on the drum.
4. Align the drum cover eyelets (Q) with the hold down
rods (T), install the cover brackets (S) and wing nuts
(R) and tighten securely (see F
. 6).
Closed Bung-Type-Drum,
Sturdi-Clamp-Mounted Pumps (F
1. Remove the adjustable bung adapter from the pump
riser tube.
2. Screw the bung adapter (EE) into the bung hole.
3. Loosen the wing nuts (BB) and slide the clamp (AA)
onto the pump riser tube, up to the base.
4. Holding the clamp onto the pump, insert the pump
riser tube through the bung adapter, and lower the
pump until the clamp rests on the edge of the drum.
5. Install the sturdi-clamp so its upper jaw fits against
the pump base projection, its u-bold (DD) fits around
the riser tube, and its lower jaw fits against the bung
adapter. Tighten the wing nuts (BB).
6. Tighten the T-handle (CC) firmly to the side of the
drum.
W Gasket
X
Drum Cover
Y
Grommet
Z
Bung Hole
F
IG
. 6
4
5
6
0
7
8
F
IG
. 7
:
;
<
=
