8
Step 5: Queen Table Supports & Table Surface Attachment
Parts Needed:
4- Table Supports
2- Table Surfaces
8- 5mmX10mm SBHC
5-1: Attach all four (4) Table Support to the Track Support with the
5mm X 10mm SBHC Screws. The Table Braces are
attached to the bottom side of the Track Support flange.
5-2: Start at one end of the Frame and remove the backing
from the Tape on the Track and Table Supports. Make sure
the TEXTURED side is facing UP. Line up the plastic Table
Surface with the Top Leg Braces and press the surface firmly
in place. Then o the same thing for the other section of the table.
Fig (4-4)
Fig (5-1)
4-4: Attach the Left Frame Corner to the Left Frame End as shown in Fig
(4-4); Use two (2) 6mm X 12mm SBHC Screws through the Left Frame
Corner and the Left Frame End into the Frame Assembly. Tighten the 6mm X
12mm SBHC Screws with the 4mm Allen Wrench.
4-5: Use two (2) 6mm X 10mm SBHC Screws to attach the front of the Left
Frame End to the Frame Assembly. Tighten the 6mm X 10mm SBHC Screws
with the 4mm Allen Wrench.
4-6: Repeat 4-4 and 4-5 to complete the Right Frame End.
Left Frame
Corner
6mmX12mm
SBHC
6mmX10mm
SBHC
Step 7: Queen Rail Assembly
Parts Needed:
3- Rail Coupler
3- Crib Aluminum Rails
3- Queen Aluminum Rails
6- Ratchet Wheels
36- 5mm X 10mm SBHC Screws
18- 5mm X 16mm SBHC Screws
Tools Required:
3mm Allen Wrench
7-1: Join a Crib Aluminum Rail and a Queen Aluminum Rail to the
Rail Coupler using twelve (12) 5mm X 10mm SBHC Screws as shown in
Fig (7-1) on each of the three rails. Tighten the 5mm Screws with a 3mm Allen Wrench.
7-2: Attach a Ratchet Wheel to one end of each rail with a 5mm X 16mm SBHC Screw, as show in Fig
(7-2).( Slide the Ratchet Wheel onto the Rail until you can see the entire nut in the hole); repeat this for
all three (3) sides of the Ratchet Wheel on both ends of the rail. Follow the same method to complete
the other Rails.
Fig (7-2)
Fig (7-1)
Step 6: Queen Track Attachment
Parts Needed:
2- Queen Plastic Tracks
6-1: Snap the Queen Plastic Track into the Track Supports
on the Front, and also the Back of the Table assembly as
shown in Fig (6-1). Start on one end of the Track, and work
your way down as the Track snaps into place.
Fig (6-1)
Note:
To remove the track, start at one
end; pry the track out with a small
screw driver and then pull it out the rest
of the way.
