Grace Industries, Inc.
2
TURN ON:
Simultaneously pressing both side PWR buttons
turns the SuperCELL® ON.
TURN OFF:
Simultaneously pressing and holding both side
PWR buttons turns the SuperCELL® OFF.
PAGE NAVIGATION:
Pressing the MENU/PWR button cycles
through the pages on the SuperCELL®.
MOTION ALARM:
If the SuperCELL® remains motionless
for the preset length of time, the SuperCELL® will sound a
repeating alarm tone and transmit man-down alarm
messages. Motion Alarm can be enabled/disabled and
the timing can be adjusted in the Setup Menu. To clear
Alarm and reset the SuperCELL®, simultaneously press the
MENU/PWR and SEL/PWR buttons.
PANIC ALARM:
Activate the Emergency Alarm by
pressing and holding the # and * buttons for 3 seconds.
When the countdown timer reaches zero, a Panic Alarm
signal will be sent and ALARM will be displayed. To clear
Alarm and reset the SuperCELL®, simultaneously press the
MENU/PWR and SEL/PWR buttons.
TOP BUTTON EVACUATION:
To send a Global
EVACUATION signal to compatible Grace Telemetry
devices (in the same family of ID’s)
Press and hold top button for 3 seconds. When the timer
reaches zero (0), and Evacuation Signal will be sent and
||| EVAC ||| will be displayed. SuperCELL® will continue
sending the Evacuation Signal until the unit is reset by
simultaneously pressing MENU/PWR and SEL/PWR buttons.
EVACUATION ACKNOWLEDGMENT:
If an Evacuate message
is received by the SuperCELL®, it can be manually
acknowledged by simultaneously pressing the MENU/PWR
and SEL/PWR buttons.
ALARM MONITORING:
Alerts the Incident Commander
that a GRACE Man-Down telemetry device, within
signaling range, is transmitting an alarm message. This alert
can be cleared from SuperCELL® by simultaneously press
the MENU/PWR and SEL/PWR buttons.
NOTE:
If an alarm has been received, SuperCELL® will not
turn off until the alarm has been cleared or reset. To force
SuperCELL® to turn off (even with an active alarm) hold down
the
Up
button along with both side
PWR
buttons.
SuperCELL® Display Icons
Quick-Start Guide
Always test SuperCELL® prior to use
Low Battery Indication / Battery Charging
When approximately 3 hours of operating time remain
in standby mode, the SuperCELL® will display a plug icon
on the display status screen. The power-on tones are not
emitted when SuperCELL® has a low battery. Low battery is
also indicated by the Operational Status LED changing to a
periodic Red strobe. A double chirp sounds once every fi ve
minutes with audio enabled.
Warning: There are no audible
low battery sounds with audio tones disabled.
When low battery is indicated, less than 3 hours of
operating time remain and the battery should be charged
immediately.
With the charger provided, recharge time is approximately
6 hours from a low battery warning and 9 hours for a
dead battery. Due to current limits imposed by Intrinsic
Safety requirements, a unit that has gone completely
dead will have to be removed from the charging base and
reinserted when the charging light turns Red. Typical
operation time between recharging is approximately 40
hours in standby/ready mode.
Plug the charger into an outlet. It takes approximately 20
seconds for the Green charger LED to light up. If it does not
turn on or a Red LED turns on, then the battery is either too
hot or cold, or has a fault.
Charging is complete when the Green charge LED starts to
slowly fl ash.
120VAC Adapter
Optional 12VDC Adapter
Green
Charge
LED
Charging Base
