Grace Industries, Inc.
7
To enable or disable the Alarm Inhibit Timer
,
proceed to the Inhibit Timer page by pressing the
MENU/PWR button. At the Inhibit Timer page, the SEL/
PWR button enables or disables the Alarm Inhibit Timer
function.
NOTE
: With the Alarm inhibit Timer enabled, the
SuperCELL® will not respond to the same alarm
message for 30 seconds after that alarm message
has been acknowledged. This allows the user of the
SuperCELL® time to operate the menu system of the
device during an alarm event.
Pressing the MENU/PWR button navigates away from
the Inhibit Timer page. Resetting the device exits out of
Setup Mode and returns the SuperCELL® to the home page.
When the Alarm Inhibit Timer is enabled
and no alarm messages have been received and
acknowledged within the 30 second inhibit time, the
Alarm Inhibit Timer Icon will be displayed as solid on
the Icon Line of the SuperCELL® display. If an alarm
message HAS been received and acknowledged, the
Alarm Inhibit Timer Icon will be displayed as empty.
This indicates that the device will not respond to an
alarm that had been acknowledged until the 30 second
Alarm Inhibit Timer expires.
Safety Certifi cations
Intrinsically Safe, Sécurité Intrinsèque
SuperCell
®
SC500 Models Intrinsically Safe per ANSI/UL913
For use in Class 1, Groups A, B, C and D; Class II, Groups E, F,
G; Div. 1 Hazardous Locations. CSA C22.2 No.157.
Temperature Code T6. IP67. Exia Rated 4.2VDC.
WARNINGS, AVERTISSEMENTS
WARNING!
To prevent ignition of hazardous atmosphere,
battery must only be charged in area known to be
nonhazardous.
AVERTISSEMENT!
Pour éviter l’infl ammation
d’une
atmosphère dangereuse, les batterie doivent être chargées
seulement dans une zone connu comme être non
dangereuse.
FCC Statements
Changes or modifi cations not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
Industry Canada Statements
This Class A digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Cet appareil numérique de la classe A est conforme à la
norme NMB-003 du Canada.(select the class for your device)
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
