B.
Crankshaft Assembly
(Figures 4 & 5)
1.
Slide the
Deltoid/Lat Slider
(6) down the
Frame Post
(3) (Figure 4). The pulleys should face the inside
of the machine.
2.
Remove the
Shaft
Collar
(25) and
Washer
(24) from the
Crankshaft
(22
)
.
3.
Insert the
Crankshaft
(22)
through the square
tab on the
Frame
Post
(3) replacing the
Washer
(24)
and
Shaft
Collar
(25), in that
order (Figure 5).
4.
Now completely thread
the
Crankshaft
through
the tab on the
Deltoid/Lat Slider
(6)
until the C
rankshaft
handle is against the square tab on the
Frame
Post
(3)
.
5.
Check that the
Washer
(24) and the
Shaft Collar
(25)
are resting on the square tab welded to the
Post Bracket
.
6.
Tighten the
Shaft Collar
(25) on the
Crankshaft
using the Allen wrench on the black
set screw in the shaft collar.
7.
Now test the
Crankshaft
by turning it counter-clockwise. The
Deltoid/Lat Slider
will rise off the
Main
Frame
if the
Crankshaft
is working properly.
8.
Finally, place the provided 1.5” square cap on top of the
Frame Post
.
C. Deltoid/Lat Slider Assembly
(Figure 6)
1.
Slide the
Deltoid/Lat Handle
(28)
onto
Deltoid/Lat Arm
(27).
2.
Push the square
Cap
(35) onto the
end of each
Deltoid/Lat Arm
.
3.
Remove the
Lock Nuts
(42) on the
bolts at both ends of
the Deltoid/Lat
Slider
(6).
4.
Mount the separately packaged
Large Pulleys
(16) making sure that
the black spacers (56) that were on
the bolts are behind each pulley.
5.
Replace the nuts and tighten them
so that they are loose enough for the
Curl Elbow Pivot Bracket
(30b) to
pivot freely.
6.
Mount the
Small Pulleys
(14w) on
the center of the
Deltoid/Lat Slider
.
Cap (35)
Deltoid/Lat
Handle (28)
Deltoid/Lat
Arm (27)
Black Spacer (56)
Figure 6
Large Pulley (16)
42
Small Pulley (14w)
42
Curl Elbow Pivot
Bracket (30b)
Frame Post (3)
Deltoid/Lat
Slider (6)
Crankshaft (22)
Washer (24)
Shaft
Collar (25)
Frame
Post (3)
Delt/lat
Slider (6)
Figure 4
Figure 5
