2"-3"Gap
Figure 9
D. Rowing Lever Assembly
(Figure 7)
1.
Cut the plastic zip ties on the
Frame Legs
(2)
where the
Rowing Levers
(5) are to be inserted.
2.
Insert the
Rowing Levers
into the
Bearings
(65). Secure them with
Shaft Collars
(32) by sliding each
Shaft Collar
over the protruding
Rowing Lever
shaft and tightening the black set screw with the Allen
wrench. Both
Rowing Levers
(5) should rest against the Row Stops.
3.
Insert the
Rowing Adjusters
(7)
into the
Rowing Levers
(5).
4.
Thread the black
Wing Handles
(12) into the
Rowing Levers
(5). These handles are used to adjust the
height of the
Rowing Adjusters
(7).
5.
Insert the Tri-Pin system into the row adjuster as shown in Figure 8, and then screw in the Bumper (40)
with the Nut (9) and put in the Plug (37).
E. Cable Installation
(Figures 9, 10, & 11)
Note: When you have finished installing the cable, as shown in Figure 8 there should be a gap of 2" to
3" between the truck arms and the stop. If you do not have this gap, the cable is incorrectly installed.
See Figure 8.
1.
Attach the
Hook Bolt
(33) to the
top of the
Frame Post
(3) using the
two nuts that were on the
Hook
Bolt
. Slide the
Hook Bolt
halfway
through the
Frame Post.
Thread
Figure 10
9
10
8
7
6
3
5
2
“front” sticker
1
Hook Bolt (33)
4
Curl Arm (30)
Shaft
Collar (32)
Rowing
Lever (5)
Row
Stop
Wing
Handle
(12)
Rowing
Adjuster
(7)
Flanged
Bearing
(65)
Bumper (40)
Nut (9)
Plug (37)
Figure 7
Figure 8
Tri-Pin
System
