44
GMC-I Messtechnik GmbH
6.16
Measuring Sequences
If the same sequence of single measurements will be run fre-
quently (one after the other with subsequent report generation),
it’s advisable to make use of measuring sequences.
Up to 10 measuring steps can be created for each measuring
sequence. The measuring steps can include measuring functions
as well as measuring instructions.
Automatic measuring sequences can be conducted in all rotary
switch positions except for
OFF
.
Measuring sequences can also be created at a PC and trans-
ferred to the multimeter with the help of
IZYTRONIQ
software.
Creating a New Measuring Sequence
➭
Select any rotary switch position other than “OFF”.
➭
Press the “MENU” key.
➭
Press the “Edit/delete new measuring sequence” softkey. The
sequence’s steps are displayed.
➭
First of all assign a name to the sequence to be created.
➭
Press the “SEQ Name” softkey to this end.
➭
Enter a name using the keyboard which appears at the display
as described on page 10.
➭
Acknowledge your entry by pressing the “Enter” softkey.
The sequence’s steps are displayed once again.
➭
You can insert a measuring step with any desired measuring
function after pressing the “Ins Function” softkey.
➭
Press the “Ins Function” key, select the desired function with
the rotary switch and acknowledge your selection by pressing
the
STORE
key.
➭
The “Information > Sequence draft > Accept function with
STORE
key” window is displayed once every 5 seconds for a
duration of 1 second.
➭
If you would like to insert measuring instructions, press the
“Ins Check” softkey.
➭
You can enter a comment for each measuring step (measur-
ing function or measuring instructions), which appears at the
display during the measuring sequence, for example “mea-
sure voltage at point XY”. Press the “Comment” softkey to this
end.
➭
Enter a text using the keyboard which appears at the display
as described on page 10.
➭
Acknowledge your entry by pressing the “Enter” softkey.
The sequence’s steps are displayed once again.
➭
Individual measuring steps can be removed by selecting the
desired step with the cursor and then pressing the “Delete”
softkey.
