Gorenje TC120SNE, Instructions For Use Manual

Page: 19 / 36

EN
19
WARNINGS!
The appliance may be used by children older than 8 years old, elderly persons and persons
with physical, sensory or mental disabilities or lacking experience and knowledge, if they are
under supervision or taught about safe use of the appliance and if they are aware of the
potential dangers.
Children should not play with the appliance.
Children should not clean or maintain the appliance without supervision.
Always transport the outdoor unit of the heat pump in an upright position; exceptionally, it
may be tilted by 35° in all directions. Be careful not to damage the housing or the vital
component parts of the appliance during transport.
The heat pump is not intended for industrial use and use in premises where corrosive and
explosive substances are present.
The connection of the heat pump to the mains should be performed in accordance with
standards for electrical appliances. An all-poles disconnect switch should be installed between
the heat pump and the mains in accordance with the national installation standards.
The heat pump should not be in operation without water in the boiler, because this could
destroy the aggregate!
The installation should be performed in accordance with the valid regulations and the
instructions of the manufacturer. It should be performed by a professionally trained installation
expert.
It is necessary to install a safety valve with a rated pressure of 0.6 MPa (6 bar) or 0.9 MPa
(9 bar) (see nameplate), to prevent the pressure in the boiler from rising by more than 0.1 MPa
(1 bar) above the rated pressure.
Water may drip from the outlet opening of the safety valve, so the outlet opening should be
set to atmospheric pressure.
The outlet of the safety valve should be installed facing downwards and in a non-freezing
area.
To ensure proper functioning of the safety valve, the user should perform regular controls to
remove limescale and make sure the safety valve is not blocked.
Do not install a stop valve between the heat pump and the safety valve, because it will
impair the functioning of the safety valve!
The elements in the electronic control unit are live even after pressing the off field (9) on the
heat pump.
To avoid danger, a damaged connecting line and connecting cable for connecting the
indoor and outdoor units can only be replaced by the manufacturer, its service provider or an
authorised person.
If you disconnect the heat pump from the power supply, please drain any water from the
pump to prevent freezing.
Water can be drained from the pump through the boiler inlet pipe. For this purpose it is
advisable to install a special element or outlet valve between the inlet pipe and the safety
valve.
Please do not try to fix any defects of the heat pump on your own. Call the nearest
authorised service company.
This product contains fluorinated greenhouse gases. Hermetically sealed.
Our products are equipped with components that are both environmentally safe and harmless to health, so
they can be disassembled as easily as possible and recycled once they reach their final life stage.
Recycling of materials reduces the quantity of waste and the need for production of raw materials (e.g.
metals) which requires a substantial amount of energy and causes release of harmful substances.
Recycling procedures reduce the consumption of natural resources, as the waste parts made of plastic and metal
can be returned to various production processes.
For more information on waste disposal, please visit your waste collection centre or the store where the product
was purchased.