Gorenje S1 IHGC963A1XUK Manual Download

Page: 10 / 16

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform “Hood Calibration”.

Hood Calibration

With the display on (ON) and the suction off (OFF), press button

for 5 seconds.

The suction speed (power) 1 starts functioning and button

flashes to indicate that hood calibration is initiated and it will

last for approx. 5 minutes.
Note: to interrupt the calibration, press

for 5 seconds; the calibration will be invalidated and should therefore be repeated.

MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switch-
ing off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.

CLEANING

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of
the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive
products.

DO NOT USE ALCOHOL!

WARNING:

Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may

cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for
any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety
recommendations.

GREASE FILTER

Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive detergents, either
by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the
grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the grease filter, press it and pull
it down.

CHARCOAL FILTER

(filter version only)

It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more or less prolonged
use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace
the cartridge at least every four mounths. In any case, the filter insert should be cleaned at least every 4 months (suitable
for dishwashers). The filter should be renewed after 36 months at the latest.

REPLACING LAMPS

The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration
up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.

For replacement, contact the technical service.