Gorenje GT64AB1-236661, Instruction Manual

Page: 24 / 100

I M P O R TA N T I N S TA L L AT I O N
S P E C I F I C AT I O N S
The installer should note that the appliance that side
walls should be no higher than the hot plate itself.
Furthermore, the rear wall, the surfaces surrounding
and adjacent to the appliance must be able to
withstand an overtemperature of 65K.
The adhesive used to stick the plastic laminate to
the cabinet must be able to withstand a temperature
of not less than 150° C otherwise the laminate could
come unstuck.
The appliance must be installed in compliance with
the provisions in force.
This appliance is not connected to a device able to
dispose of the combustion fumes. It must therefore
be connected in compliance with the above
mentioned installation standards. Particular care
should be paid to the following provisions
governing ventilation and aeration.
5) ROOM VENTILATION
It is essential to ensure that the room in which the
appliance is installed is permanently ventilated in
order to allow the appliance itself to operate
correctly. the necessary amount of air is that
required for regular gas combustion and ventilation
of the relative room, the volume of which must not
be less than 20 m
3 . Air must naturally flow through
permanent openings in the walls of the room in
question. These openings must vent the fumes
outdoors and their section must be at least 100 cm
2
(see fig. 3). Construction of the openings must
ensure that the openings themselves may never be
blocked. Indirect ventilation by air drawn from an
adjacent room is also permitted, in strict compliance
with the provisions in force.
CAUTION: if the burners of the cooking top are
without safety thermocouple, the ventilation
outlet must have a minimum 200 cm² section.
6) LOCATION AND AERATION
Gas cooking appliances must always dispose of their
combustion fumes through hoods. These must be
connected to flues, chimneys or straight outside. If it
is not possible to install a hood, an electric fan can be
installed on a window or on a wall facing outside
(see fig. 4). This must be activated at the same time as
the appliance (see fig. 5), so long as the specifications in
the provisions in force are strictly complied with.
INSTALLATION
24