Gorenje Classico EC52CLI1, Instructions For Use Manual

Page: 13 / 17

EN 12
LOCATION
Solely company authorized to provide such
activities may perform the installation of this
hotplate and it should be installed in compliance
with local standards and regulations.
This appliance is intended for installation into a
normal internal environment (for instance kitchen,
dwelling space, etc.).
This appliance can be not installed in a bath room
and similar rooms with higher humidity.
It can be mounted in a kitchen line without side gap
(the minimal space in the furniture is 500 mm).
To the appliance close walls and furniture (floor,
kitchen rear wall, side walls) should be resistant
against temperatures up to 100°C or a suitable
thermal insulation should be used.
The distance between the cooking plate and the
kitchen hood should be minimally 650 mm („X“), or
according to recommendation of the hood producer.
The appliance is designed for location directly on the
floor. Do not use any base or pedestal
.
LEVELING THE APPLIANCE
Cooker hob must be leveled in horizontal position by
means of 4 leveling screws supplied with the
appliance.

Remove the cooker receptacle;

Tilt the cooker on one side;

Screw plastic screws into the bottom crossbar
front and rear openings on one side;

Tilt the cooker on the opposite side and fix the
screws into the openings on the other side;

Level the cooker using a screwdriver from the
receptacle area, or by turning the leveling screw
with a hexagon wrench;
The procedure is less complicated if performed by
using leveling screws.
NOTE
Leveling screws are unnecessary if the appliance
height and horizontal position are acceptable.
WARNING
In order to prevent tipping of the appliance, this
stabilizing means must be installed.
INSTALLATION
The stabilizing agent against overturning appliances
- console - is as shown attached to the wall using
dowels and screws. Subsequently, the appliance is
placed against the wall so that the attached bracket
is inserted into the hole in the rear wall.
INSTALLATION PROCEDURE

Set the cooker to the designated place, or align
with adjustability.

Pull out the cooker and measure the distance "A"
from the floor.

Screw the wall bracket as shown (one screw into
the center of the slot).

Push the cooker into place and verify the
functionality of the console (or height-adjustable
bracket).

Pull out the cooker and attach the second bracket
screw.

Slide the cooker into place.