Gorenje Plus GHV62B, Instruction On Mounting And Use Manual

Page: 40 / 116

OPERATION
Use the high suction speed in cases of
concentrated kitchen vapours. It is
recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and
to leave in operation during cooking and for
another 15 minutes approximately after
terminating cooking.
This model is equipped with a perimetric
suction panel.
The panel allows to optimize the
performances of the hood.
T1 - ON/Stand By
- select T1 to access, set and start any
function of the hood:
the control icons, which can be selected by
the user, will be lit (low intensity light)
NB = icon T9 will remain off since it is a
saturation indicator. It will however be
possible to access settings by following the
procedure described in paragraph “Charcoal
filter/grease filter use status”.
T2 - Light ON/OFF
SL1 - Increase/Decrease light intensity
- press T2 to switch the lights on
- skim your finger to the right over the
control to increase the intensity of the light
(intensity 1 --- > intensity 9) ;
- skim your finger to the left over the control
to decrease the intensity of the light
(intensity 9 --- > intensity 1);
- press T2 to switch the lights off
NB = the light switches on for the first time,
by default, with intensity 1; it will
subsequently light up with the intensity it
had when it was switched off.
T3 - Auto Ventilation
- press T3 to activate the auto ventilation
function
- the suction speed will initially start at the
second speed, then it will be automatically
set by the sensor.
- press T3 to deactivate the auto ventilation
NB = the auto ventilation function will
deactivate itself if the user operates other
functions that adjust speed during auto
ventilation.
NB= if the sensor cannot connect properly,
the motor will not switch on and an acoustic
signal will be triggered for 10 seconds.
NB - special cases of sensor operation
1) if the sensor sets the “Timing or Timing
x2” speed, suction will still return to the ninth
speed after 5 minutes;
2) if there are no speed variations for 10
minutes, the hood switches off and the auto
ventilation function is deactivated;
Hob selection
This operation optimises the operation of the
hood in auto ventilation mode;
with the motor off, proceed as follows:
- press T3 for 5 seconds:
T5 and T6 switch on.
- press T5 to select the
Gas cooktop ;
press T6 to select the Electric cooktop :
NB = the gas cooktop is selected by default
Sensor calibration
This operation is important for correct
operation of the sensor, which regulates the
hood in auto ventilation mode;
it must be performed:
- at the first switch-on of the hood
- when selecting/changing the hob
- whenever any malfunctioning of the hood
40