Please note: The wall plugs included with this product are suitable
for solid walls only. Plasterboard or stud walls may require
specialised fixings which are not provided. (Always ensure that the
wall plugs or fi�ngs are correct for the wall type.)
Where possible drill between �les in the grout.
WARNING: Failure to follow these instruc�ons may result in
personal injury, damage to the product and property damage.
Failure to follow these instruc�ons may result in personal injury,
damage to the product and property damage.
"Preven�on of frost damage.
When the domes�c water system is drained, thermostat mixers
must be drained seperately, since non-return valves are installed in
the hot and cold water connec�ons. For this purpose, the mixer
must be removed from the wall."
Always be aware of the danger of scalding from hot water. Ensure
users are aware of the maximum temperature especially if the
temperature stop has been adjusted.
Never twist or kink the hose or otherwise restrict the water flow
whilst in use.
This product must be connected to a water supply in accordance
with the Water Supply (Water Fi�ngs) Regula�ons 1999, and UK
Building Regula�ons. If you are in any doubt about these
requirements, contact a qualified plumber, your local Water
Company or the Water Regula�ons Advisory Service (WRAS).
This guarantee is in addi�on to and does not affect your statutory
rights. Declara�on of Performance available on www.diy.com
It is important to that both supply pipes are flushed before
connec�ng mixing valves to ensure no pipe/plumbing debris enters
the mixing valves.
TURN OFF WATER MAINS SUPPLY. The mains stopcock is usually
situated where the supply enters the building.
It is also recommended that the water hea�ng arrangements are
turned off.
Isolate the hot and cold water supply.
Opera�ng Specifica�on:
Hot Water Supply - Maximum. 85˚C
Recommended 55-65˚C
Opera�ng Pressure: Maximum 5 Bar
Always maintain a 50˚C difference between the hot system
temperature and the maximum hot temperature se�ng of the
valve.
Please note that although these instruc�ons are comprehensive, it
is always recommended that a technically competent installer
should undertake the installa�on
Opera�ng pressures on hot and cold lines should be kept as even as
possible in order to ensure the maximum effciency of the mixer.
When water pressure is higher than 5 bar a pressure reducing valve
(not supplied) must be fi�ed before the mixer.
Each shower valve is supplied with integral non return valves in the
hot and cold inlet tail pieces to prevent cross flow and cross
contamina�on of the water supplies.
This product must be connected to a water supply in accordance
with the Water Supply (Water Fi�ngs) Regula�ons 1999, and UK
Building Regula�ons. If you are in any doubt about these
requirements, contact a qualified plumber, your local Water
Company or the Water Regula�ons Advisory Service (WRAS).
This product is under warranty for
2
years as from the date of purchase,
for normal, non-professional household use. The warranty shall only
apply upon presenta�on of the �ll receipt or the invoice. Keep your proof
of purchase in a safe place.
The warranty applies to domes�c use only. The warranty covers product
replacement or repair if a manufacturing fault is found during the
warranty period, which begins on the date of purchase.
The warranty covers product breakdowns and malfunc�ons under the
condi�on that the product is used in accordance with its intended use and
subject to installa�on and maintenance in accordance with good prac�ce
and the informa�on contained in the user’s manual.
This product must be installed so that it may be later removed without
damaging it.
This contractual warranty does not cover defects and damage caused by
thenatural wear of parts, discolora�on caused by light, bad weather,
flooding, heat releases, freezing, damage caused by water quality
(hardness, aggressiveness, corrosion, etc.), by the presence of foreign
bodies transported by water or otherwise (sand, filings, etc.) or the lack of
room ven�la�on, and damages that could be the consequence of
improper use, misuse, negligence, accident or maintenance that is
defec�ve or does not comply with good prac�ce or the informa�on in the
user’s manual.
The following are also excluded from the warranty: harmful consequenc
-
es due to the use of accessories and/or non-original equipment
manufacturer or improper replacement parts, disassembly or product
modifica�on.
The warranty is limited to those parts recognised as defec�ve. Under no
circumstances shall it cover fringe expenses (travel, labour) and direct and
consequen�al damage.
This guarantee is in addi�on to and does not affect your statutory rights.
Distributor: B&Q plc, Chandlers Ford, Hants, SO53 3LE United Kingdom
www.diy.com
SFD Limited, Trade House, Mead Avenue, Yeovil, BA22 8RT,
United Kingdom
It is important to keep this manual for the warranty to apply for usage and
maintenance of your furniture.
4
Summary of Contents for 3663602487760
