MS400
Translation of the original operating instruction and spare parts list
- 21-
5007045-00
BA-E
®
Important: Observe all the previous chapters in this manual, in particular the safety
and warning instructions!
5.
Operation
5.1 Before starting the machine
Before starting observe the following points:
•
Make sure that the blade is correct installed and the blade guard is closed. The blade guard must
always be fitted when cutting.
•
Defective or worn blades must be replaced immediately.
•
Make sure that the blade is not touching the cutting table at any position of the cutting table or
cutting head.
•
Fill the water tank with clean water and make sure the water pump in completely immersed in the
water. The water pump doesn't run without water refill the water tank with clean water if
necessary.
•
Supply cooling water to the blade by the water pump.
•
The material to be cut must not exceed the following:
Weight < 10 kg - 22 lbs.
Max. Dimensions: 600 x 500 x 135 mm - 23,6 x 19,7 x 5,3 in.
The machine only is operated in safe operating condition!
Pay attention to the dispositions of cooling water and flushing water as well as cutting muds. Cutting
muds must be absorbed, filtered and disposed of.
5.2 Starting the machine
To start the machine, open the cover of the switch and press the green button.
After starting the machine check immediately the following points:
•
The cooling water must be transported in sufficient quantity from the water pump to the blade.
The water should drain on both sides of the blade.
•
The water nozzles and water hoses should not clog.
If one of these points is not correct, stop immediately the machine!
The motor is equipped with a thermal protection to prevent high temperature rises, if the thermal
protection triggers, wait until the motor has cooled down before starting the machine again.
5.3 Cutting operation
Attention:
Location rid of anything that might interfere with the operation! Ensure
correct installation of the blade! With the exception of the operator, should be no
other persons present in the work area!
Warning: Never touch rotating parts!
