BS 400P
- 29-
5009001-00
BA-D-E-F-FL
®
5.4 Stop cutting operation
To stop the machine, press the red button or directly
the emergency switch to stop the machine.
The motor and the water pump shut off.
Carry out the maintenance and care work according to
the chapter "maintenance and care".
5.5 Changing the blade
The blade must be changed if:
the diamond segments of the blade are
completely worn
the material to be cut changes
the blade turns irregularly
the diamond segments are damaged or broken
For fitting a new blade, proceed as described in the
chapter "Mounting / changing the blade".
6.
Maintenance and care
Spare parts must comply with the technical
requirements specified by the manufacturer. Spare
parts from
GÖLZ
®
can be relied to do so! Observe the
following indications:
In accordance to the given cycles, the subsequently
described maintenance work has to be enforced. Also
the wearing parts subject to no certain maintenance-
intervals have to be checked regularly for wear and to
adjust if necessary or to exchange.
Be
fore
st
artin
g
wo
rk
Aft
er wo
rk
Weekl
y
In t
he
eve
nt of a malfu
ncti
on
If
da
mag
ed
Complete
machine
check
x
x
x
clean
x
Flange
clean
x
replace
x
Engine shaft
clean
x
Engine (housing
and fan)
clean
x
Water tank
clean
x
Water pump
check
x
x
clean
x
Water hoses
deplete
x
Water nozzle
clean
x
Guiding rail and
guiding roller
clean
x
Screw fittings
check
x
6.1 Machine
Clean the machine after each duty and check all
functions. Replace all necessary parts that are out of
order or worn out immediately.
6.2 Blade
When ending a cutting job - check blade as
follows:
Check segments for cracks or break-outs, Cracks
between segment and core barrel, Deformation
and out of round wear.
In case of doubt, send the blade for repair.
7.
Troubleshooting
Cause
Remedy
Machine doesn’t work
No electrical power
supply
Check the power cable.
Check the power
connection.
Defective power cable
Change the power cable
Defective switch
Change the switch
Defective engine
Change the engine
Attention: All maintenance, repair and
care work is only to be done if the
motor being stopped and the power
supply is disconnected!
7
