89
GENERAL DOOR PANEL INSTALLATION
DOOR PANEL INSTALLATION
This programming mode allows to assign to a monitor / telephone a push button of the general door
panel that it wishes to call.
Before the push button of the general door panel must be programmed with backbone and
monitor/telephone code, (see page 88).
Programming the monitor/telephone:
Locate the SW2 configuration dip switch of the general door
panel to program, placed at the upper left side (back) of the
sound module. With the switch 1 to OFF and 3 to ON, set the
switch 2 to ON: to show that the system is ready for
programming, the general door panel will reproduce a tone.
Then program the monitor/telephone, as it is described on corresponding monitor / telephone manual,
(see page 74 for manual web link).
Bear in mind the configuration dip switch (as it is described in the previous step).
P
rogramming the monitors and telephones from a general door panel.
D
escription of the function connector CN3.
The function connector Cn3 is located at the upper left side of the back of
the sound module.
Plug the cable that is supplied with the module, to realize the following
functions:
10
1
9
2
8
3
7
4
6
5
Top view CN3
Description connector CN3
ð
"AP" function: It activates the relay of the lock release "CV1" and "Cv2", configurable activation
time of 3 or 15 seconds via dip switch SW1-2 (page 85), see connections (page 106).
ð
"ICO" function: For the busy channel indication, it will be realized with terminals "ICO" and "+12".
ð
"Handicap" function: Synthese vocale from FDI (France). The connector includes all wires for
connection (see page 106).
1 Grey (-) Ground.
2 Brown (+12) 12Vdc for activation the lock release.
3 White
(ICO) Busy channel indicator.
4 Yellow (AP)
External push button to activate the lock release.
5 Violet (+H)
For activation of an external illumination.
6 Blue
(OP)
Handicap.
7 Orange
(SC) Handicap.
8 Green
(ALM) Handicap.
9 Red
(PDB) Handicap.
10 Black (-)
Ground.
90
DOOR PANEL INSTALLATION
F
inal adjustments.
P
lace the nameplate labels.
Open the label holder.
Place the label and
close.
Once finished the works of wiring, configuration and
final adjustments, fix the frame in the embedding
box with the supplied screws.
C
lose the frame.
If after starting the system it
's considered that the audio
volume isn
't correct, proceed with the necessary
adjustments as shown
.
in the drawing
The telecamera has a pan and tilt mechanism built in to
adjust the telecamera position.
