PORTER'S EXCHANGE DESCRIPTION
8
D
escription of the Sw2 configuration dip- switch.
1
2
3
4
SW2
The Sw2 configuration dip-switch is located at the lower left side of
the back of the porter's exchange.
Plus System
Plus
, loads the installation with a communications resistor
.
For a proper system operation, placed to ON only in the closest door
panel to the backbone installation or in the general door panel (if exists),
set the rest to OFF. If not there are door panels, set to ON only in the
closest porter's exchange to the backbone installation.
Allows to reset the administrator PIN code (see page
to the factory
default. Use this function only in case to forget this code.
disassemble the porter's exchange from the connector and set
the dip-switch to ON, then place the porter's exchange to the connector,
the message
will appear on screen when the
message disappears disassemble the porter's exchange again and set the
dip-switch to OFF; place the porter's exchange to the connector (the PIN
code is now the factory default).
To proceed:
RESET SWITCH IS ON
,
11
)
Not used.
*Factory default.
D
escription of the clock battery.
Uno System
Uno
, loads the installation with a
communications resistor
. For a proper system
operation, set to ON only in the closest door panel to the backbone
installation, placed the rest to OFF. If not there are door panels, set to
ON only in the closest porter's exchange to the backbone installation.
In the backbone installation or after the inner door panel in systems with
general door panels, placed the door panel/s and porter's exchange to
OFF.
With digital repeater RDPlus-UnoSE:
1
2
3
4
BK0
+
The first time that the porter's exchange is connected to the installation, it is
necessary to activate the function 'enable clock battery' by means of the
menu, (see page 49 .
programming
)
If the hour is lost in porter's exchange due to a cut-off of electricity, check that the
function 'enable clock battery' in the programming menu is activated (see page 49). If this is correct, it
will be necessary to replace the battery.
Replacement battery: Golmar code (50121403 battery CR1220).
When replacing the battery, check the polarity, as it is shown on the drawing.
Important:
BK0
BK1
