23
TELEPHONES PROGRAMMING
P
rogramming the telephones.
13:15
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
With the door release push button pressed
switch on the telephone.
To enter the porter's exchange into program mode,
press key
and enter the administrator PIN code
(factory default: 1315), as described on page 47.
To show that the system is ready for programming, the porter's
exchange will reproduce a sound and the display will show
the message
. At this moment, the door
release push button can be released. Lift the handset
to stablish audio communication with the porter's exchange.
program mode
Enter the code that will be used to call to
this telephone and press the OK key.
At this moment the porter's exchange
will reproduce a sound
and the telephone led will blink.
To program the telephone as master,
switch it off and on again.
To program it as slave, press the door
release push button.
To program it as slave with intercom
function press the center push button.
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Repeat these steps to program the rest of telephones.
Once the programming has been finished exit from the programming menu by pressing
CANCEL key. If you don't, the door porter's exchange will automatically exit after
two minutes with no operation.
On systems with door panels, telephones and monitors programming must be done
from the door panels, as described on the corresponding instruction manual.
Once the programming has been finished, make a call from each apartment to the
porter's exchange: the display will show the corresponding assigned codes.
If no door panels are installed, program the telephones as follows.
.
Program the system with the porter's exchange handset lifted
0
1
1
a bc 2
d ef 3
j k l 5
mno6
t uv8
wxyz9
a bc 2
d ef 3
j k l 5
mno6
t uv8
wxyz9
