H
old the door panel on the embedding box
.
Select a direction to open the door panel; this selection should ease
the door panel wiring
The opening direction will be settled through the hinges position,
that must be passed through the header clips as shown.
For example, if the hinges are placed on both clips of the lower
header, the door panel will open downwards; if they are placed
on the right clips of both headers, the door panel will open to left
.
.
To hold the door panel on the embedding box,
insert the hinges in the embedding box
lockers as shown
.
DOOR PANEL INSTALLATION
Link the sound module with the
EL500/R5 microprocessed circuit
by using the supplied flat cable
.
104
DOOR PANEL INSTALLATION
A
ssembling the EL500/R5 microprocessed circuit and the EL516SE
push buttons encoders
.
The EL500/R5 circuit is to be assembled on the top of the
embedding box Insert the circuit in the
the embedding box (1) Push-in the
flanges (2) by pressing
top flanges of
circuit in the bottom
the pcb board
.
.
.
To assemble the EL516SE encoder, screw the top tab of the
case to the corresponding plastic lug of the embedding
box
Place the circuit on the lower flanges and screw it into
the embedding box
In case of more than one encoder, place them underneath
or in the next embedding box
The use of EL516SE encoders is only necessary for panels
with more than 8 push buttons
Each encoder allows to connect 15 push buttons,
obtaining a maximum of 120 push buttons by using 8
encoders
.
.
.
.
.
1
2
A
ssembly of the sound module
.
Insert the sound module in the grille module.
For a proper assembly, align the light push
button and the microphone rubber of the
sound module with its corresponding holes
in the grille module.
103
