Goldwing YAK 55M 70 E, Instruction Manual

Page: 9 / 31

ARF® MODEL

Appropriate servo arms

Servo wire extensions. two 6”, two 12”

Appropriate Lipo batteries (6S 2600-3300mah)

Receiver of your choice (minimum 4 channels)

RC radio of your choice
Shop Supplies/Tools

Covering Iron and heat gun

Hobby tools such as screwdrivers, hobby knife, drill and drill bits, piers, etc.

Thick and Thin CA adhesives

30 minute Epoxy

Isopropyl alcohol

Ruler or tape measure

Blue thread-lock or equivalent

Adhesive backed Velcro and Velcro strap for battery retention
Note: please read all the instructions before you begin construction. Handle the parts of this kit with
care so you do not damage any of the structure or covering. Inspect all the parts for any shipping
damage and report any issues to as soon as you can. Make sure you have a flat and sturdy workbench
and follow all safety advice for the tools and adhesives you plan to use .
Aircraft Covering
Varying temperatures and storage delays can cause covering material to loosen over time and
transportation. We recommend lightly going over all the covering with a covering iron set at
medium temperatures . Be sure to use a soft cover over your iron so you do not scratch the covering
surface. Be sure you go over all seams and edges of the covering to assure it is secure to the airframe
and other covering. Be careful not to apply too much heat or you may cause bubbles or damage to the
covering. A heat gun may also be used along with a soft cotton cloth to shrink and adhere the
covering . Again, be extremely careful when using a heat gun.