ARF® MODEL
input. If the aircraft climbs when inverted then you’ve probably got your CG too far aft. If the
nose drops more than slightly, then you are most likely nose heavy.
Recommended control surface deflections:
Low Rate
High Rate
Elevator 15 degrees
45-50 degrees
Rudder
25 degrees
40-45 degrees
Ailerons 25 degrees
35-40 degrees
10.Final Assembly and Pre-Flight Inspections
10.1 Before arriving at your flying field, be sure all your batteries are properly charged and all
radio systems are in proper working order.
10.2 Install the wings onto the fuselage being careful to align the wing tube with the wings and not
force it. The wing tube may be initially tight but will loosen some with use. Guide your servo
wires into the fuselage openings and connect to the proper aileron channels. Servo clips are
recommended. Once you have the wings fully seated in the fuselage tighten the wing bolts inside
the fuselage.
10.3 Cut the wing film needed to be install the SFG. Fixed the SFG Use M3X18 hand bolts and
wood sheets. Installation of the SFG is optional.
Summary of Contents for YAK 55M 70 E
Page 1: ...ARF MODEL 60in YAK55M 70 Electric Electric Extreme Series Instruction Manual ...
Page 7: ...ARF MODEL Honeycomb Board carton packing for safer transportation Scheme A White red blue ...
Page 31: ...ARF MODEL KUZA new Wingbag for 70E Two color to choose orange silver blue silver No KAG0091 ...
