All contents copyright 2014, GoldWing RC Version 2.0, Feb 2014
2. Be sure to seal any exposed wood with a thin coating of epoxy to prevent engine oil from soaking in. This
is especially important around the engine compartment and servo openings with exposed areas.
3. Some modelers prefer to seal the hinge gaps using strips of appropriate covering or clear trim tape. We
have found this to be helpful with models intended for higher speed flight or models with unusually large
hinge gaps. Our aircraft utilize a very tight double beveled hinge line and do not normally require this step.
Sealing the hinge gaps is therefore left as an option for the modeler.
Please verify the accessories before commencing assembly:
Carbon Fiber control Horns (Bag No. KA17CA) : 20 single horns for ailerons and elevator. 2 dual horns
for rudder.
Sand the area of the horn that will be glued to help adhesion.
Adjustable pushrods kits: (Bag No. KA17CB) Ten 3x60mm pushrods for ailerons & elevator. Three
3x40mm pushrods for rudder.Two 3x125mm pushrods rudder
（
Pull-push style
）
