All contents copyright 2014, GoldWing RC Version 2.0, Feb 2014
10. Check the operation of the rudder using your radio and make sure there is no binding and the cables are
adjusted properly. You may have to tighten the cables after a few flights as they may stretch slightly from the
initial installation.
11
．
The MX2 also provides pull-push style for rudder. Below is picture of pull-push style linkage set.
12.
Cut off excess carbon fiber rudder horn, and use sandpaper to rough the parts needed to inlay, and use
epoxy glue to glue the horn in place.
13. Use 3x165mm push rod between the servo and the rudder horn. Then use the wrench to adjust the
pushrod to the appropriate length.
