extensions. Your installation
though may vary.
Note: As with all kits, it’s a good idea to read all the instructions
and study the parts before you begin construction. Handle the
parts of this kit with care so you do not damage any of the
structure or covering. Inspect all the parts for any shipping
damage and report any issues to as soon as you can. Make sure
you have a flat and sturdy workbench and follow all safety advice
for the tools and adhesives you plan to use.
AIRCRAFT COVERING
1. With all ARFs, varying temperatures and storage delays can cause
covering material to loosen over time and transportation. recommends
lightly going over all the covering with a covering iron set at medium
temperatures. Be sure to use a soft cover over your iron so you do not
scratch the covering surface. Be sure you go over all seams and edges
of the covering to assure it is secure to the airframe and other covering.
Be careful not to apply too much heat or you may cause bubbles or
damage to the covering. A heat gun may also be used along with a soft
cotton cloth to shrink and adhere the covering. Again, be extremely
careful when using a heat gun.
2. Be sure to seal any exposed wood with a thin coating of epoxy to
prevent engine oil from soaking in. This is especially important around
the engine compartment and servo openings with exposed areas.
3. Some modelers prefer to seal the hinge gaps using strips of appropriate
covering or clear trim tape. We have found this to be helpful with
models intended for higher speed flight or models with unusually large
hinge gaps. aircraft utilize a very tight double beveled hinge line and
do not normally require this step. Sealing the hinge gaps is therefore
left as an option for the modeler.
Summary of Contents for Corvus Racer 540 120CC
