24
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, you must remove the right
pedal, the right access disc, and the right shield as
described below.
Using an adjust-
able wrench, turn
the Right Pedal (26)
counterclockwise
and remove it. Then,
using a standard (flat)
screwdriver, release
the tabs around the
edge of the right
Access Disc (10),
and then remove it
from the Right Shield (18).
See assembly step 5 on page 9.
Using a stan-
dard (flat) screwdriver, release the tabs along the
bottom edges of the Rear and Front Shield Covers (9,
19), remove the two M4 x 12mm Screws (61), and then
remove the Rear and Front Shield Covers.
See the EXPLODED DRAWING on page 27.
Remove all of the screws from the Left and Right
Shields (17, 18);
there are two sizes of screws in
the shields—note which size of screw you remove
from each hole.
Then, gently remove the Right Shield.
Loosen the M6 x 20mm Hex Screw (60). Then, tighten
the M10 x 50mm Hex Screw (33) until the Drive Belt
(23) is tight.
When the Drive Belt (23) is tight, tighten the M6 x
20mm Hex Screw (60).
Then, reattach the left and right shields, the right
access disc, and the right pedal.
26
18
10
23
60
33
Summary of Contents for CYCLE TRAINER 400 R
Page 4: ...4 STANDARD SERVICE PLANS ...
