background image

Goldline 

GLDUAL 

manual April 2015

 

positions are indicated by a large and small flame graphic on the glass plate next to each 
individual control knob.  

BURNER OPERATION

  

1. Depress the required control knob anti-clockwise to the FULL-ON position.  
2. When the burner has ignited, adjust the control knob to the required setting. Flame 

adjustment is achieved by rotating the control knob further in an anti-clockwise fashion  

BATTERY REPLACEMENT

 (applicable to battery ignition model)  

1. Open the battery holder cover flap  
2. Remove old battery  
3. 

Replace with new 1.5 Volt “D” size battery noting correct polarity 4. Close cover flap 

 

CLEANING  

Allow the hob cooker to cool before attempting to dismantle or clean it. The glass  
 

plate is best cleaned with a cloth, using warm soapy water. Use of abrasive 

powders   

and pastes should be avoided as far as possible, but when necessary 

use only a mild    abrasive. For removal of hardened grease, very fine steel wool, 
wetted and liberally   

soaped, can be used.  

Caustic solutions, washing soda, aerosol spray cleaners, bleach and some biological  
 

cleaners are detrimental to some surface finishes and care must be taken not 

to   

apply them to the burner bodies and caps. 

  

Do not wash burner caps in a dishwasher.  

For ease of cleaning, remove spillage from the bowls as soon as possible. Control  
 

knobs may be pulled off for cleaning beneath them, but take care not to allow 

water to   

enter the holes in the glass plate.  

When re-assembling the spillage bowl always ensure that it is correctly located over  
 

the spark electrode. Care should be taken to keep the electrode clean and 

avoid   

damage to the porcelain insulator when removing the spillage bowl 

during cleaning.  

It is recommended that the appliance should be clean as describe above daily for  
 

optimal performance and longer life expectancy.  

Wash spill bowl regularly and clean dirt and grease in a weekly basis.  

Check the burner port regularly for blockage especially if there is occurrence of  
 

spillage and clean them if necessary.  

MAINTENANCE SCHEDULE

 

 

-   

It is recommended that to have the units serviced by an authorized person at least  

 

once a year.  

Summary of Contents for GLDUAL 4 BZLPG-Cast













Reviews: