12
9.0 INSTRUCTIONS FOR SERVICE
INSTRUCTIONS TO REMOVE THE BOARDS AND THE HEAD.
1. Use T10 Torx driver to remove 6 screws holing control module in place.
2. Remove the control module.
3. Remove cable connecting the boards.
4. Control Module Removed
1
2
3
4
Remove keyswitch connector
Remove 3 screws holding processor board to top
Remove processor board.
Disconnect ribbon cable.
Remove the 8 screws that hold the housing together
Remove half the housing.
Remove the head.
Loosen the four screws that hold the feedback wires in place.
