![background image](http://html.mh-extra.com/html/goldair/platinum-gpph610/platinum-gpph610_operating-instructions-manual_2239964007.webp)
Installation Instructions
The appliance must not be located immediately below a socket outlet.
NOTE: Your Panel Heater should be installed with at least 150mm clearance from the
floor and any other surrounding parts including other appliances and side walls.
At least 300mm clearance from ceilings, shelves and soft furnishings.
Note: Do not run the power cord behind the heater.
WALL MOUNTED HEATERS ARE
ONLY TO BE MOUNTED ON HEAT
RESISTANT WALLS THAT COMPLY
WITH CURRENT AS/NZS
SPECIFICATIONS & BUILDING
REGULATIONS
150mm
300mm
150mm
150mm
WALL MOUNTED
1.
Make sure the appliance is unplugged and power switches are off.
2.
Position the panel appliance within one metre of a wall socket. Do not mount in front of or
below the wall socket. Ensure there is at least 150mm clearance on all sides of the
appliance.
3.
Detach the mounting bracket from the back of the panel appliance by unscrewing the two
locking screws (located on the top of the mounting bracket).
4.
Position the mounting bracket on the wall and mark the hole positions with a pen or pencil
and check they are horizontal with a spirit level. Ensure the two bottom mount holes are at
least 150mm from the floor and drill holes as required.
5.
Secure the mounting bracket to the wall with the mounting screws. (For masonry walls use
the plastic sheaths).
6.
Slot the back of the appliance onto the mounting bracket locating the bottom plugs first
and secure with two locking screws.
7.
Plug appliance into a standard 240 volt AC electrical outlet.