Operating your Micathermic Heater
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday
– Friday 8am-5pm
Phone: 0800 232 633
Website: www.Goldair.co.nz
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate operating
position.
The second device, automatically disconnects &
reconnects the appliance at a preset temperature.
The third device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse. (It is non resettable)
IMPORTANT! NEVER COVER THIS HEATER!
Covering the heater will cause activation of the non
resettable safety fuse.
CARE AND CLEANING
Do not attempt to dismantle the Micathermic Heater.
There are no user serviceable parts. For service or
repair, contact an authorised electrical service
technician. The outer shell may be cleaned with a
soft, damp cloth. You may use a mild detergent if
necessary. After cleaning, dry the unit with a soft
cloth. CAUTION: DO NOT let liquid enter the heater.
CAUTION
The Micathermic Heater generates heat during use.
Proper precautions must be taken to prevent the risk
of
burns, scalds, fires or other damage to persons
.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
HEAT CONTROL SWITCH
The control switch positions are:
0 OFF
I Low Heat
II High Heat
Check that the heat control switch is set to off
position before plugging the heater into the
mains supply. For greater economy, use the
high heat setting initially and then switch to
the low heat setting.
THERMOSTAT
Turn the thermostat knob clockwise until the
maximum temperature is obtained on the
graduated
scale.
When
the
desired
temperature is reached, slowly turn the knob
anti-clockwise until the heater turns off (you
will hear a click). The heater will now cycle on
and off to maintain the set temperature.
CAUTION: never install the heater directly
beneath a socket-outlet or in such a way that
people in the baths, showers or pools may
have to touch live parts such as a switch.
Important: The radiator must be connected to
an earthed outlet of the appropriate voltage.
Note: When the heater is turned on for the
first time, it may release a slight, odour or
smoke. This odour or smoke is a normal
occurrence caused by the initial heating of the
internal heating elements and should not
occur again.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
WARNING: THIS IS A DOUBLE SIDED HEATER. Keep all objects at least 1
metre from the front, sides and rear of the appliance.
